RAD Data comm ASMI-450 Manual de usuario descargar pdf (Pagina 34)

Chapter 3 Configuration Management User's Manual

3-12 Setting Operational Parameters LRS-24 RADview/TDM

3. Fill in the fields, as described in

Table 3-4.

4. Click <Set> to implement the changes.

Table 3-4. Card Parameters

Parameter Values / Remarks

Slot A unique identification of the card slot position in the LRS-24 hub

IO-1..IO-12

Read-only

Card Type ASMi52/CD/CD4w/CQ

Read-only

Clock Source For ASMi-52/CD/CD4w/CQ:

Internal-Central, External-Central, System-Central, Receive-Remote

Note: External and Local-Ext are disabled for the interfaces:

ETH-UTP, IP-UTP, ETH-Q, or ETH/BNC

Clock Source Port This field is enabled only if the value displayed in Clock Source field is External, Local-Ext,

Remote-Rcv, or Receive

Modem-1, Modem-2, Modem-3, Modem-4

For ASMi-52 family, this field is enabled for DTE= E1 only.

SHDSL

Transmission

Mode

For ASMi-52/CD/CD4w/CQ

Annex A=bit 0 – region 1

Annex B=bit 1 region 2

Read-write only for Central Unit (Modem Port Line Clock Source <> receive)

Other parameters are Set for the card level. There is only one profile for each card, and

there is no option for adding another profile to this card, or removing the exsisting one

Resetting the Card

This section explains how to reset the modems on the card according to the last

changes saved, as well as to the default factory setting.

Card Reset is enabled only for LRS-24 version higher than 3.0 for IMOD cards:

\ASMi52/CD/CD4w/CQ.

Resetting to Last Saved Configuration

The Reset command resets all the modems on the card to the last configuration

that was saved.

 To reset the card:

1. In the LRS-24 View window, select the relevant IMOD card (as described in

Managing Cards

2. Right click and select Configuration > Card Reset.

Note

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 159 160

Sin comentarios

RAD Data comm ASMI-450 Manual de usuario Pagina 34