RAD Data comm ASMI-450 Manual de usuario descargar pdf (Pagina 137)

User's Manual Chapter 6 Fault Management

LRS-24 RADview/TDM Managing Modem Alarms 6-7

Clearing Alarms in the Alarm Buffer

You can clear the alarm history log contained in the LRS-24 Alarm Buffer.

This is applicable only for ASMi-51CD/CQ, ASMi-52CD/CQ/CD4W and some SMODs.

 To clear all alarms in the LRS-24 alarm buffer:

• In the Zoom view, select the modem (near end or far end), right click and

select Fault > History Log > Clear.

The alarm buffer is cleared.

All active alarms are eventually reactivated and then reappear in the LRS-24

Modem Active Alarm List and Alarm Buffer, shown above.

Masking Modem Traps

You can specify the modem trap you want to mask.

This is not supported for SMODs. For additional information, see Updating System

Installation Registry.

 To mask a trap:

1. In the Zoom view, select the modem (near-end or far-end), right click and

select Fault > Mask Traps.

Figure 6-6. Mask Modem Traps Dialog Box

2. In the Traps area, select the traps to be masked, by selecting the relevant

check box, as follows:

 Select Alarms to mask all alarm traps.

 Select Status to mask status traps.

3. Click <Set> to mask the selected traps.

Note

1 2 ... 132 133 134 135 136 137 138 139 140 141 142 ... 159 160

Sin comentarios

RAD Data comm ASMI-450 Manual de usuario Pagina 137