RAD Data comm 100 Especificaciones descargar pdf (Pagina 61)

Installation and Operation Manual Chapter 1 Introduction

Egate-100 Ver. 4.0 Functional Description 1-29

bridge port is shut down. Egate-100 continues to send loop detection frames,

and detects the end of the loop after three consecutive loop detection frames do

not return, upon which transmission resumes at the bridge port.

Diagnostics

Several types of diagnostics and troubleshooting procedures are available:

• Ping test and self-test

• E1/T1 PRBS tests for E1/T1

• Events/traps.

Alarms and traps can be masked by user configuration.

For more information, refer to

Chapter 5

Hierarchically-layered traps/alarms – events resulting from events that were

already reported and are still active – are not sent. For example, LOF event traps

are not sent if LOS was sent and the physical layer problem persists.

Statistics Collection

Egate-100 provides the following diagnostic information:

• Statistics for physical ports, logical ports, bridge ports, flows and RADIUS

• Active alarms and a log file at STM-1/OC-3, channelized T3, Gigabit Ethernet, and

system levels.

For more information about monitoring statistics, see

Chapter 5

Configuration Reset

When required, the Egate-100 configuration parameters can be reset to their

default values. In addition to resetting to the factory-set values, Egate-100 allows

you to save the current settings as the device default settings, replacing the original

factory default settings. It is then possible to return to the saved settings when

using the Reset to Factory Defaults option from the configuration menu.

When required, the saved settings can be erased completely, restored the default

settings to the original factory default values.

Note

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 317 318

Sin comentarios

RAD Data comm 100 Especificaciones Pagina 61