
Chapter 7 Application Tutorial Installation and Operation Manual
7-6 User and Management Traffic Separated by VLAN Egate-100 Ver. 4.0
CONTROL
Egate-100
RDY
ALM
12
LIN K
MNG-ETH
LIN K
ACT
GbE
ACT
1 2
STM-1/OC-3STM-1/OC -3
LINK
SYNCSYNC
DCE
Figure
7-7: CONTROL Connector
Connecting to the Network Management Station
Egate-100 is connected to an NMS via an 8-pin RJ-45 connector designated
MNG ETH. Refer to
Appendix A
for the connector pinout.
³ To connect to an NMS:
• Connect Egate-100 to a hub or switch using a straight cable
Or;
• Connect Egate-100 to a network interface card using a cross cable.
When connecting Fast Ethernet cables longer than 30 meters (98 feet), it is
recommended to use shielded cables.
CONTROL
Egate-100
RDY
ALM
12
LIN K
MNG-ETH
LIN K
ACT
GbE
ACT
1 2
STM-1/OC-3STM-1/OC -3
LINK
SYNCSYNC
DCE
Figure
7-8: Fast Ethernet Management Connector
Connecting to Power
Egate-100 can be ordered with either AC power or DC power (single or dual
power supply).
Connecting to AC Power
AC power is supplied to Egate-100 via a standard 3-prong plug.
AC power should be supplied through the 1.5m (5 ft) standard power cable
terminated by a 3-prong plug. The cable is provided with the unit.
Note
Comentarios a estos manuales