
Installation and Operation Manual Chapter 7 Application Tutorial
Egate-100 Ver. 4.0 IP DSLAM and WiMAX Backhauling over SDH/SONET 7-25
CONTROL
Egate-100
RDY
ALM
12
LIN K
MNG-ETH
LIN K
ACT
GbE
ACT
1 2
STM-1/OC-3STM-1/OC -3
LINK
SYNCSYNC
DCE
Figure
7-32. SDH/SONET SFP Connectors
Connecting to Gigabit Ethernet Equipment
The Egate-100 GbE interface terminates in 8-pin RJ-45 (electrical) or LC (optical)
connectors.
³ To connect to the Gigabit Ethernet equipment with fiber optic SFP:
• Connect Egate-100 to the Gigabit Ethernet network equipment using a
standard fiber optic cable terminated with an LC connector. Refer to
Installing
Fiber Optic SFP Modules
for details on installing fiber optic SFPs.
CONTROL
Egate-100
RDY
ALM
12
LIN K
MNG-ETH
LIN K
ACT
GbE
ACT
1 2
STM-1/OC-3STM-1/OC -3
LINK
SYNCSYNC
DCE
Figure
7-33: Gigabit Ethernet SFP Connectors
³ To connect to the Gigabit Ethernet equipment with a copper interface:
• Connect Egate-100 to the Gigabit Ethernet network equipment using a
standard straight UTP/STP cable terminated with an RJ-45 connector.
When connecting Gigabit Ethernet cables longer than 30 meters (98 feet), it is
recommended to use shielded cables.
CONTROL
Egate-100
RDY
ALM
12
MNG-ETH
LIN K
GbE
1 2
STM-1/OC-3STM-1/OC-3
SYNCSYNC
DCE
LIN K
Figure
7-34: Gigabit Ethernet 10/100/1000BaseT Electrical Connectors
Connecting to Management Stations
Egate-100 can be connected to a local ASCII terminal via the CONTROL port or to
a remote network management station via dedicated Ethernet management port.
Connecting to the Terminal
Egate-100 is connected to an ASCII terminal via a 9-pin D-type female connector
designated CONTROL. Refer to
Appendix A
for the connector pinout.
Note
Comentarios a estos manuales