RAD Data comm 100 Especificaciones descargar pdf (Pagina 25)

Installation and Operation Manual Quick Start Guide

 Default Priority Tag

 Replace Priority Tag. Yes or No

 Egress Tag Handling. None, Stripping, Stacking

 Ingress Tag Handling. None, Stripping, Stacking

 Loop Detection. Disabled or Enabled

 Link OAM (802.3ah). Disabled or Enabled

 Maximum MAC Adress. 1 – 64000

 VLAN ID

 Active Timeslots for framed physical ports only (1-31 or a list of values

for E1, 1-24 for a list of values for T1).

Configuration using Standard Menus

This section describes how to configure the required parameters using the full

menu structure.

³ To configure the host parameters:

• In the Host menu (Main > Configuration > System > Management

> Host), configure the following parameters:

 IP Address

 IP Mask

 Default Gateway.

³ To configure the host encapsulation:

• In the Encapsulation menu (Main > Configuration > System > Management

> Host> Encapsulation), configure the following parameters:

 Host Tagging (untagged/tagged)

 Host VLAN ID (for tagged only)

 Host VLAN Priority (for tagged only).

³ To configure the Ethernet interfaces:

• In the Ethernet menu (Main > Configuration > Physical Layer > Ethernet),

press <F> or <B> to select the Gigabit Ethernet port under Port, and then

configure the following parameters:

 Alarms: Specify whether to mask or unmask the alarms

 Autonegotiation: Enable or disable autonegotiation mode.

The Autonegotiation option is only available for electrical interfaces, not for

optical interfaces.

Note

³ To configure STM-1/OC-3 interfaces:

• In the SDH/SONET menu (Main > Configuration > Physical Layer

> SDH/SONET), configure the following parameters:

Egate-100 Ver. 4.0 Configuring Egate-100 5

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 317 318

Sin comentarios

RAD Data comm 100 Especificaciones Pagina 25