RAD Data comm LRS-24 Especificaciones descargar pdf (Pagina 34)

Chapter 3 Configuration Installation and Operation Manual

3-2 Entering Commands ASM-40CD Ver. 1.0

Table 3-1. LRS-24 Screens

Screen Indication

LRS-24 cards Indicate slot number in which the modem is installed,

and the type of SNMP management associated with the

module, via either on-board agent (SMOD) or CM-2

agent (IMOD). The ASM-40CD module is IMOD type.

Hub alarm Indicates whether a modem alarm is active or not. The

active alarm associated with a specific modem is shown

in the MODEM ALARMS STATUS screen. For details

regarding the ASM-40CD alarms, see

Alarm Buffer

and

Using Alarm Messages

Chapter 4

Hub log file Indicates time and data of events, such as modem

removal from or insertion to the hub.

3.2 Initiating an ASCII Terminal Session

 To enable an ASCII terminal session:

1. Connect the terminal to the CM-2 RS-232 connector of the LRS-24 hub.

2. Power-up the CM-2 module.

The opening screen

shown in

Figure 3-1

appears followed by the

Cm2> prompt.

L RRRR SSS 222 4 4

L R R S 2 2 4 4

L RRRR SS ---- 2 444444

L R R S 2 4

LLLL R R SSS 22222 4

RAD DATA COMMUNICATIONS

Figure 3-1. LRS-24 Terminal Session Opening Screen

3.3 Entering Commands

The commands listed in

Table 3-2

enable you to access ASM-40CD screens. After

the CM-2> prompt appears, type one of these commands to to view the desired

screen. In the command phrases indicated below,

denotes the number of the

slot in which the ASM-40CD module is installed, where nn = 1 through 12.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 75 76

Sin comentarios

RAD Data comm LRS-24 Especificaciones Pagina 34