RAD Data comm LRS-24 Especificaciones descargar pdf (Pagina 29)

Installation and Operation Manual Chapter 2 Installation and Operation

ASM-40CD Ver. 1.0 Interfaces and Connections 2-5

Setting Internal Jumpers

The DTE1 and DTE2 jumpers serve for selection of the serial interface type

(see

Figure 2-4

DTE1

DTE2

Figure 2-4. Interface Module LRSI-F-5 Jumpers and Fuses

 To select the serial interface type:

• V.24, X.21, RS-530 and V.36 – Set the DTE1 and DTE2 jumpers over the P1

and P2 pins.

• V.35 – Set the DTE1 and DTE2 jumpers over the P2 and P3 pins.

Installing the Interface Module into the Chassis

 To install the interface module in the LRS-24 chassis:

1. Insert the interface module into the upper section above the ASM-40CD

module of the LRS-24F chassis, or back section of the LRS-24B chassis.

2. Fasten two front panel screws to secure the module to the LRS-24 frame for

proper grounding.

2.5 Interfaces and Connections

The ASM-40CD modem is connected to the line and DTE via the interface module.

Identify the necessary cables for the interface module you have installed and

prepare the line and DCE cables.

Use

Table 2-4

to prepare the line cable.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 75 76

Sin comentarios

RAD Data comm LRS-24 Especificaciones Pagina 29