
127
5
RAD Data Communications 2011 Catalog
•
Transparent modem concentrator
•
Operates 16 SHDSL, E1 modems on
2-wire
•
Multiple data rates: between 64 kbps
and 2,048 kbps
•
ITU-T standards: G.703, G.704
•
Compact unit
using a dedicated management port, while
maintaining separation between management and
user traffic via the use of VLANs. Advanced FCAPS
(Fault, Configuration, Administration, Performance,
Security) and diagnostic tools are provided by
RADview-EMS, RAD’s carrier-class element
management system, via an SNMP-based GUI. The
LRS-16 also supports a variety of access protocols,
including SNMP, Web server, and Telnet.
LRS-16 is supplied in a 1U-high 19-inch enclosure.
The LRS-16 is a managed SHDSL modem
concentrator presenting a cost-effective central-
site solution for point-to-point extension of E1
services in the Local Loop.
The concentrator can operate opposite 16
ASMi-52 SHDSL modems at remote locations,
providing E1 services over 2-wire lines. Each
one of the 16 fixed ports inside the LRS-16 can
have its own separate clocking.
Extended range
LRS-16 employs standard SHDSL TC-PAM 16
technology to extend the transmission range,
thus enabling carriers to reach more customers
at lower costs. The device uses an embedded
operation channel (EOC) for controlling and
monitoring the remote unit. The management
channel uses SHDSL overhead bits in compliance
with ITU-T G.991.2 requirements, and operates
without interfering with the data transmission.
Power supplies
LRS-16 operates with single or dual power
supplies. A power supply can be hot-swapped
(replaced) during operation, without affecting
system performance.
Management
The LRS-16 features flexible management
capabilities, including local management via an
ASCII terminal (RS-232). In addition, remote
management can be performed either inband
using the network or user ports or out-of-band
LRS-16
Managed SHDSL Modem Concentrator
For latest updates visit www.rad.com
ASMi-52
Backbone
NMS
Switch
E1s
LRS-16
SHDSL 2W
E1
PBX
ASMi-52
Router
Up to 16
V. 35
SHDSL 2W
•
High density 19" modem rack
(up to 14 cards)
•
Central solution for copper and fiber
modems
•
Compact – 4U-high
•
Hot-swappable cards and power
supplies
•
Indicator LEDs on each card
•
Fully redundant power supply
•
Optional power feeding from different
power sources (AC or DC)
ASM-MN-214
Chassis for Short Range Modems
The ASM-MN-214 versatile modem rack is a
high density unit capable of housing any
combination of up to 14 cards.
The ASM-MN-214 accommodates two separate
power supplies. Each power supply supports a
full rack of any combination of cards. The power
supplies can be either AC or DC and are suitable
for power redundancy. Replacement during
operation (hot-swapping) is possible, with no
effect on the modems and their data
transmission.
Cards that are currently supported: ASM-10/8/R,
ASM-31/R, ASM-40-1/R, FOM-20/R, FOM-40/R,
FOM-E1T1/R, FCD-2L/R, RIC-E1/R, RIC-T1/R.
The ASM-MN-214 has a terminal block for the
line interface and a 25-pin connector for the
digital interface. The terminal block is a snap-
type connector for easy replacement.
An optional mechanical adapter, the CIA, is used
to convert the 25-pin connector to the required
physical connector for either V.35 or X.21
interfaces.
ASM-40
RIC-E1/
RIC-T1
FOM-E1/T1
FOM-40
4-wire; 1.75 km (1.1 miles); up to 2.048 Mbps
Fiber optic; 100 km (62 miles); G.703; 1.544 or 2.048 Mbps
Interface converter; 1.544 or 2.048 Mbps
Fiber optic; 100 km (62 miles); up to 2.048 Mbps
ASM-MN-214
For latest updates visit www.rad.com
MODEM AND MULTIPLEXER RACKS
Comentarios a estos manuales