RAD Data comm ASMi-52 Manual de usuario Pagina 87
- Pagina / 186
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Installation and Operation Manual Chapter 4 Configuration
ASMi-52 Ver. 2.5 Additional Tasks 4-37
ASMi-52
System Status
Local Remote
Device Type (ASMi52_SA_M (PLASTIC)-STU_C-2W)
ASMi52_SA
Clock Source (INT) RCV
Software Version (2.01E24) (2.01E24)
Hardware Version (0.00) (0.00)
FPGA Version (0.13) (0.13)
Hardware Status (NO HARDWARE FAILURE) (NO HW
FAILURE)
PS (WIDE RANGE PS 48-60 VDC/100-240 VAC)
(WIDE RANGE)
MAC address (0 20 D2 20 5F AB) (0 20 D2 21
12)
IP address (172.17.161.73)
(172.17.161.75)
Alarm Indication NORMAL NORMAL
Test Indication (OFF) (OFF)
>
ESC-prev. menu; !-main menu; &-exit;
Figure 4-39. System Status Screen
•
Alarms are described in Chapter 5.
Displaying the Port Status
To display the port status information:
1. From the Physical Port Status menu, select Port Status (Main menu >
Monitoring > Physical Port Status > Port Status) to display the port status.
The Port Status menu appears (see Figure 4-40).
ASMi-52
Port status
Local Remote
SHDSL (Standard ANNEX_B, Wire mode 2W) ______
SHDSL Line (Status: SYNC, State: DATA mode) ______
Framer Type (SLOTTED E1) ______
EOC compatible (PROPRIETARY) ______
Actual PSD (ASYM_PSD_DISABLE) ______
Line rate (2048 kbps + 8 kbps) ______
E1 interface (IR-G704-E1/BALANCE Data rate: 2048 kbps) ______
HW status (NO HARDWARE FAILURE) ______
Test status (NONE)> ______
Alarm status (NORMAL) ______
REM connected line (1) ______
(N)
ESC-prev. menu; !-main menu; &-exit;
Figure 4-40. Port Status Menu
Note
- /4-Wire SHDSL Modem 1
- ASMi-52 3
- Limited Warranty 4
- General Safety Instructions 5
- Handling Energized Products 6
- FCC-15 User Information 8
- Warning 9
- Declaration of Conformity 10
- Quick Start Guide 11
- Configuring the E1 Interface 12
- Configuring the T1 Interface 13
- Contents 15
- Table of Contents 16
- DTE Interface 17
- Line Interface 17
- Unit Enclosure 18
- Functionality 20
- Multiplexer Applications 23
- Management 25
- Statistics Collection 26
- Alarm Reporting 26
- SHDSL Repeaters 26
- 1.4 Technical Specifications 28
- Environment 31
- Chapter 2 33
- Installation and Setup 33
- 2.3 Package Contents 34
- Connecting the Line 35
- Connecting the DTE Interface 35
- Chapter 3 37
- Operation 37
- Preparing the Terminal 43
- Data Terminal Ready (DTR) 43
- Initiating a Control Session 43
- Correcting Entries 44
- Navigating Data Forms 44
- Configuration Menus 47
- Chapter 4 51
- Configuration 51
- Entering Device Information 52
- Configuring the LAN Port 57
- Configuring Aging Timeout 59
- Configuring QoS Mapping 59
- Setting the LAN Rate 60
- Configuring Autonegotiation 61
- Configuring Fault Indication 62
- Configuring Remote Card Mode 65
- Selecting the CTS State 67
- Selecting the DSR State 67
- Timeout 68
- Configuring the Snext Margin 73
- Configuring Line Probing 75
- Selecting E1 Framing Mode 79
- Setting the Sync Mode 80
- Defining Idle Code 81
- Mapping E1 Timeslots 81
- Displaying the System Status 86
- Displaying the Port Status 87
- Accessing the Remote ASMi-52 88
- Updating Software Releases 91
- Resetting ASMi-52 95
- Resetting the ASMi-52 Modem 96
- Resetting the SHDSL Repeater 97
- Chapter 5 99
- Configuring a Typical 99
- Application 99
- ASMi-52 Ver. 2.5 100
- Setting the E1 Port 101
- Chapter 6 105
- Troubleshooting and 105
- Diagnostics 105
- Displaying All Alarms 113
- Masking Port Alarms 115
- 6.4 Troubleshooting 119
- BERT Patterns 121
- Running Loopback Tests 123
- Running the Local Loopback 124
- Running the Remote Loopback 126
- Deactivating the Loopbacks 127
- 6.7 Technical Support 129
- Appendix A 131
- Interface Connector 131
- Specifications 131
- Ethernet Connector 133
- A.2 CONTROL Connector 134
- A.3 Alarm Relay Connector 135
- Appendix B 137
- IR-IP Interface Module 137
- B.2 Technical Specifications 138
- B.3 Physical Description 139
- IR-IP LEDs 140
- Normal Indications 140
- IP Learning Mechanism 143
- General Operating Procedures 145
- ASMi-52 with IR-IP 147
- LAN IP Address: 192.168.1.2 149
- Mask: 255.255.255.248 149
- DHCP Server 149
- IP Network 149
- Defining a Telnet Password 150
- B.9 Advanced Setup 151
- Frame Relay Protocol 153
- PPP Protocol Menu 154
- Downloading New Software 157
- Viewing the Error Log 157
- Reset LAN 158
- Reset WAN 159
- Viewing the ARP Tables 160
- Using the Ping Function 163
- B.14 Erasing IR-IP Software 164
- Erasing Application Software 165
- B.15 IR-IP Troubleshooting 166
- Appendix C 167
- Easy Config Device 167
- C.3 Installation 168
- C.4 Operation 169
- Assigning Timeslots 172
- ASMi-52 Ver. 2.5 I-5 177
- E1, 4-32 177
- Supplement 179
- Customer Response Form 181
- Error Report 183
Relacionado con productos y manuales para Gateways / Controladores RAD Data comm ASMi-52
(12 paginas)© 2020, manymanuals.es. Todos los derechos reservados | 0.045 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales