RAD Data comm ASMi-52 Manual de usuario descargar pdf (Pagina 172)

Appendix C Easy Config Device Installation and Operation Manual

C-6 Operation ASMi-52 Ver. 2.5

7. Press the x button to select the value.

The s character designating space is stored in the bottom row:

111s

8. Repeat steps 4–7 to enter the remaining values. Mind the spaces between the

IP address portions.

The resulting display should look as follows:

111s222s33s44s

9. Press the ENTER button to complete the data entry.

10. Select Save from the Management menu.

Assigning Timeslots

The Easy Config offers an alternative method of the E1 or T1 timeslot assignment.

Instead of moving the cursor in the menu to every timeslot and assigning it to carry

data or idle code, it is possible to specify assigned timeslots directly.



To assign timeslots:

1. From the Time Slot Assignment menu (Configuration > E1 Configuration > E1

Local Port Configuration > Time Slot Assignment), select 34 CLEAR to

disconnect all timeslots.

2. Hold down the z button, and press the x button to initiate the alphanumeric

value enter mode.

3. Enter the numbers of the timeslots to be assigned to carry data, as explained in

the Entering Alphanumeric Values section above. The timeslot number must be

separated by spaces (character s).

The resulting display should look as follows:

11s12s13s14s

4. Press the ENTER button to complete the entry.

• Up to four timeslots can configured at a time.

• Timeslot 0 can be configured to the loop or transparent mode only via the

menu.

5. Save the changes.

Turning the Easy Config Off



To turn the Easy Config off:

• Set the top panel BAT switch to OFF and disconnect the AC/DC power

adapter from the mains.

Notes

1 2 ... 167 168 169 170 171 172 173 174 175 176 177 ... 185 186

Sin comentarios

RAD Data comm ASMi-52 Manual de usuario Pagina 172