RAD Data comm HCD-E1 Especificaciones descargar pdf (Pagina 88)

Appendix A Connector Wiring LRS-24 Installation and Operation Manual

A-4 Power Connectors

A.5 Ethernet Interface Connector – LRSI-F1-CM2 Module

The 10BaseT Ethernet interface located on the LRSI-F1-CM2 module is terminated in

an RJ-45 connector, designated Management Ethernet 10BT, and wired in accordance

with Table A-5. Note that the wiring depends on the settings of the jumpers on the

LRSI-F1-CM2 module, as explained in Section 2-5.

Table A-5. LRSI-F1-CM Module, Ethernet Interface Connector

Pin Function

Jumpers JP1 - JP5 on Pins 1-2 Jumpers JP1 - JP5 on Pins 2-3

1 Input: Receive Data wire + Output:Transmit Data wire +

2 Input: Receive Data wire – Output: Transmit Data wire –

3 Output: Transmit Data wire – Input: Receive Data wire –

4 Not connected Not connected

5 Not connected Not connected

6 Output: Transmit Data wire + Input: Receive Data wire +

7, 8 Not connected Not connected

A.6 Ethernet Interface Connector – LRSI-F2-CM2 Module

The 10Base2 Ethernet interface located on the LRSI-F2-CM2 module is terminated

in a BNC connector designated Management Ethernet 10B2.

A.7 Power Connectors

The AC-powered PS modules have one standard IEC three-pin socket with integral

fuse, for the connection of the AC power.

The DC-powered PS modules have one three-pin circular connector, for the

connection of the –48 VDC input voltage. Connector wiring is listed in Table A-6.

Table A-6. DC Power Connector, Pin Functions

Pin Function

1Ground

2 Not connected

3–48 VDC

Order from: Cutter Networks

Ph:727-398-5252/Fax:727-397-9610

www.bestdatasource.com

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 149 150

Sin comentarios

RAD Data comm HCD-E1 Especificaciones Pagina 88