RAD Data comm FCD-IP Manual de usuario descargar pdf (Pagina 69)

RADview FCD-IP User’s Manual Chapter 3 Port Management

Configuring Protocol Parameters 3-31

Figure 3-21. DLCI Table

Table 3-20. DLCI Table Parameters

Parameter Possible Values / Remarks

Interface The selected interface.

DLCI # Specifies DLCI number.

State Specifies state of DLCI.

Active, Inactive (for receive/transmit)

CIR Value Specifies maximum number of data bits that the network guarantees to transfer

during the measurement interval.

Excess Value Specifies maximum number of uncommitted data bits the network attempts to

deliver during measurement interval.

Throughput Value Specifies the average number of data bits pre second transferred by the network.

When CIR is defined as one second, Throughput Value should also be one second.



To add an entry to the DLCI Table:

1. In the DLCI Table, click <Add...>.

The Add DLCI dialog box appears.

2. Configure the desired parameters (see Table 3-20).

3. Click <Set>.

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 109 110

Sin comentarios

RAD Data comm FCD-IP Manual de usuario Pagina 69