RAD Data comm FCD-IP Manual de usuario descargar pdf (Pagina 48)

Chapter 3 Port Management RADview FCD-IP User’s Manual

3-10 Configuring Physical Parameters

Table 3-7. Interface Information – Ethernet LAN Parameters (Cont.)

Parameter Possible Values / Remarks

Active Address

Burn In MAC Changing this parameter will cause disconnection with the agent.

Locally Administered Changing this parameter will cause disconnection with the agent.

LAN State

Enable, Disable

Selecting Disable for this parameter will cause disconnection with the agent.

Routing/Bridging

Bridge, IP Router, IPX Router, IP and IPX Router, IP Brouter, IPX Brouter,

IP and IPX Brouter

Note: Only for two LANS.

3.3 Configuring Physical Parameters

This section describes how to view and configure physical layer parameters of

Async, ISDN, E1/T1, and SHDSL ports.

• For information on configuring interface information, see Configuring Interface

Information.

• When configuring TDM parameters a password is required.

Configuring Async Link (V.24) Physical Parameters

Async links can only be V.24.



To configure Async physical parameters:

1. Select the Async Link.

2. Select Configuration > Physical Parameters…

The Async Link Parameters dialog box appears.

3. Configure the desired parameters.

4. Click <Set>.

Notes

Note

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 109 110

Sin comentarios

RAD Data comm FCD-IP Manual de usuario Pagina 48