RAD Data comm IPmux-8 Especificaciones Pagina 64
- Pagina / 116
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Chapter 4 Diagnostics and Troubleshooting IPmux-11 Installation and Operation Manual
4-12 Performance Monitoring Statistics
Monitoring>Status>Connection
Destination IP address: (1.1.1.1)
Next hop MAC address: (000000000000)
Connectivity status: > (OK)
Sequence errors: (0)
Jitter buffer underflows: (0)
Jitter buffer overflows: (0)
1. Bundle ID ... (1)
>
ESC-prev.menu; !-main menu; &-exit 1 Mngr/s
Figure 4-9. Connection Screen
Table 4-4 lists the bundle connection parameters.
Table 4-4. Bundle Connection Parameters
Parameter Description
Destination IP
Address
The IP address of the opposite IPmux, to which the bundle is destined.
Next Hop MAC
Address
Layer 2 Applications: the MAC address displayed is the MAC address of the remote IPmux-11.
Layer 3 Applications: the MAC address displayed is the MAC address of the connected router.
Connectivity
Status
Disabled: No activity in the channel. The channel is disabled.
OK
: Both the remote and the local IPmux receive Ethernet frames, (however, there may be problems
such as sequence errors, underflows, overflows, as explained below).
Local Fail: The local IPmux-11 does not receive Ethernet frames.
Remote Fail
: The remote IPmux-11 does not receive Ethernet frames.
Unavailable: The remote IPmux-11 does not reply to OAM messages (only applicable when OAM is
enabled).
Validation Fail
: The remote IPmux-11 replies, but there is a configuration error (only applicable when
OAM is enabled).
Standby: Redundant bundle is OK and wiaitng for redundancy switching (only applicable when
Redundancy is enabled).
TDM Fail
: There is LOS/LOF at the TDM side (only applicable when Redundancy is enabled).
Note: While under Disable or Local Failure or Remote Failure status, the statistic counters will be
inactive.
- IPmux-11 1
- Limited Warranty 4
- General Safety Instructions 5
- Handling Energized Products 6
- FCC-15 User Information 8
- Warning 9
- Quick Start Guide 11
- Configuring Internal Bridge 12
- Contents 13
- Table of Contents 14
- List of Figures 15
- List of Tables 16
- Chapter 1 17
- Introduction 17
- Features 18
- To calculate distance: 19
- TDMoIP Operation Modes 19
- Management 20
- 1.2 Physical Description 20
- 1.3 Functional Description 21
- External Network Timing 22
- Single Source Clock Network 23
- MAC IP UDP 24
- Packet Delay Variation 25
- PDVT (Jitter) Buffer 26
- Ethernet Throughput 27
- Round Trip Delay 28
- OAM Connectivity 29
- End-to-End Alarm Generation 29
- VLAN Traffic Behavior 30
- Ethernet Ports 30
- Rate Limiter Option 31
- 1-16 Functional Description 32
- Table 1-10. Mode C 33
- Table 1-11. Mode D 33
- Table 1-12. Mode E 34
- Table 1-13. Mode F 34
- Table 1-14. Mode G 35
- 1.4 Technical Specifications 36
- Chapter 2 39
- Installation and Setup 39
- 2.3 Installation and Setup 40
- Connecting AC Power 41
- Connecting DC Power 41
- Chapter 3 43
- Operation 43
- 3.2 Operating Instructions 44
- 3.3 Getting Started 45
- Choosing Options 46
- Saving Changes 46
- Web Browser Requirements 46
- Tdm Configuration (T1) 47
- ETH Configuration 47
- Diagnostics Ping 48
- Loopback 48
- Self Test Results 48
- 3.5 Default Settings 49
- 3-8 Default Settings 50
- Default Settings 3-9 51
- 3-10 Default Settings 52
- Chapter 4 53
- Diagnostics and 53
- Troubleshooting 53
- Displaying Events 54
- Clearing Events 55
- Table 4-1. Event List 56
- E1/T1 Statistics 58
- Table 4-2. E1/T1 Statistics 59
- LAN Statistics 62
- Bundle Connection Statistics 63
- 4.3 Diagnostic Tests 67
- 4-16 Diagnostic Tests 68
- 4.4 Troubleshooting 69
- 4.5 Alarm Relay 70
- A.1 E1 and T1 Connector 73
- A.2 Ethernet Connectors 74
- A.3 CONTROL Connector 74
- A.4 External Clock Connector 75
- Appendix B 77
- Boot Sequence and 77
- Downloading Software 77
- Software 78
- Appendix C 81
- SNMP Management 81
- MIB Structure 82
- SNMP Communities 83
- Authentication 84
- Network Management Stations 84
- Appendix D 85
- Configuration Menus 85
- Defining Network Managers 90
- Defining Management Access 91
- Configuring User Access 92
- Masking Alarms 93
- Control Port Parameters 94
- Setting Date and Time 94
- TR-6211 (10 seconds) 98
- Fast (1 Second) 98
- None 98
- Robbed Bit 98
- D.8 Resetting IPmux-11 107
- Figure D-32. Utilities Menu 108
- 48/60VDC~100-240VAC/ 109
- Customer Response Form 111
- Error Report 113
© 2020, manymanuals.es. Todos los derechos reservados | 0.068 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales