RAD Data comm IPmux-11 Información técnica descargar pdf (Pagina 40)

Chapter 3 Configuration Management User's Manual

3-24 Additional Tasks RADview-SC/TDMoIP IPmux-11

3.3 Additional Tasks

Displaying Ethernet Interface Information

The Ethernet Interface Information command enables you to display the various

parameters of the Ethernet port. You can use this information as a troubleshooting

aid, to ensure that the Ethernet cable is working properly and that the connection

is at the appropriate speed at half/full duplex.



To display information about the Ethernet interface:

1. Click the Ethernet port.

2. Select Configuration > Interface Info...

The Interface Information table appears.

Figure 3-19. Interface Information – Network/User Port

Table 3-12. Interface Information Table Parameters

Parameter Possible Values / Remarks

Port

NETWORK, USER

Type

ETH

MAC Address MAC Address

Mode Transmission mode: Full Duplex, Half Duplex

Rate (Mbps) Transmission rate: 10, 100

Status Status of the link: Connected, Not Connected

Interface Type According to wavelength and laser mode

1300nmSM or 1300nm (single mode/multimode)

Note: Only for fiber optic Ethernet interface

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 89 90

Sin comentarios

RAD Data comm IPmux-11 Información técnica Pagina 40