RAD Data comm ASM-10/8 Especificaciones Pagina 30
- Pagina / 56
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Chapter 2 Installation and Setup ASM-10/8 Installation and Operation Manual
2-4 Installation and Setup
Table 2-1. ASM-10/8 Internal Jumpers and Switches
Item Jumper Description Values Default Setting
1 SWITCH Enables activation of DIG, ANA and
REM loopbacks via the front-panel
pushbuttons
EN – The loopbacks can be
activated via the front panel
DIS – The loopbacks cannot be
activated via the front
panel
EN
2 2W/4W Selects 4-wire or 2-wire operation 4W – 4-wire operation
2W – 2-wire operation
4W
Note: When using 2-wire operation, connect both wires to the XMT screws of the terminal.
3 AGC Controls the AGC operation
Refer to Configuration Considerations
below for detailed explanation of the
AGC settings.
ON – AGC is always active
CTRL – ACG is active only when
DCD turns on
ON
Note: When set to CTRL, ACG remains at its last level of amplification if DCD goes off.
4 CARRIER Selects the transmit carrier mode. ON – Transmit carrier is
constantly On
CTRL – Transmit carrier is On
only if RTS is high
ON
Note: Set CARRIER to CTRL when using ASM-10/8 in multipoint applications.
5 XMT LEVEL Selects the transmit output level to the
line
0 dbm
-3 dbm
-6 dbm
-9 dbm
0 dbm
6 XMT IMPD Selects transmit line impedance
600
300
150
LOW
150
Note: Set XMT IMPD to LOW when using ASM-10/8 in multipoint applications.
7 RPF Enables the Remote Power Failure
notification (ASM-10/8/R only)
ON – RPF notification enabled
OFF – RPF notification disabled
ON
Note: Set RPF to OFF when using ASM-10/8 in multipoint applications.
8 PIN 18 Controls the local analog loopback
activation via the DTE pin 18
EN – The analog loopback
activation from the DTE
enabled
DIS – The analog loopback
activation from the DTE
disabled
EN
- SM-10/8 1
- ASM-10/8 3
- Limited Warranty 4
- General Safety Instructions 5
- Handling Energized Products 6
- FCC-15 User Information 8
- Warning 9
- Declaration of Conformity 10
- Quick Start Guide 11
- 2 Installing ASM-10/8 12
- Connecting the Cables 13
- 2. Operating ASM-10/8 14
- Contents 15
- List of Figures 16
- List of Tables 16
- Chapter 1 17
- Introduction 17
- 1-2 Overview 18
- Features 19
- Transmission Range 20
- Diagnostics 20
- 1.2 Physical Description 21
- 1.3 Functional Description 22
- Modulation Timing 23
- Async to Sync Converter 23
- Receiver 23
- V.54 Diagnostics 24
- 1.4 Technical Specifications 25
- 1-10 Technical Specifications 26
- Chapter 2 27
- Installation and Setup 27
- 2.3 Installation and Setup 28
- Opening the ASM-10/8 Case 29
- 2-4 Installation and Setup 30
- Configuration Considerations 32
- XMT RCV GND 33
- Connecting the Power 34
- Chapter 3 35
- Operation 35
- 3.2 Operating ASM-10/8 36
- Normal Indications 37
- Turning Off ASM-10/8 37
- 3-4 Operating ASM-10/8 38
- Chapter 4 39
- Local Analog Loopback (LLB) 40
- V.54 Loopback Tests 4-3 41
- Local Digital Loopback (DIG) 42
- Chapter 5 43
- ASM-10/8/R Card Version 43
- 5-2 ASM-MN-214 Card Cage 44
- 5.2 Power Supply 45
- 5.3 ASM-10/8/R Front Panel 46
- Connecting the Interfaces 48
- Appendix A 49
- Connector Wiring 49
- Figure 1 51
- Customer Response Form 53
- Error Report 54
Relacionado con productos y manuales para Redes RAD Data comm ASM-10/8
Redes RAD Data comm ASMi-52CQ Especificaciones
(100 paginas)
(100 paginas)
Redes RAD Data comm FOM-E3 Manual de instrucciones
(33 paginas)
(33 paginas)
Redes RAD Data comm 146 Manual de usuario
(202 paginas)
(202 paginas)
Redes RAD Data comm LA-210 Especificaciones
(210 paginas)
(210 paginas)
Redes RAD Data comm FOMi-T1 Especificaciones
(58 paginas)
(58 paginas)
Redes RAD Data comm MBE10-8D Manual de usuario
(6 paginas)
(6 paginas)
Redes RAD Data comm T1 Especificaciones
(158 paginas)
(158 paginas)
Redes RAD Data comm HCD-E1 Especificaciones
(232 paginas)
(232 paginas)
Redes RAD Data comm FCD-X21 Manual de instalación
(224 paginas)
(224 paginas)
Redes RAD Data comm LA-210 Manual de usuario
(158 paginas)
(158 paginas)
Redes RAD Data comm ASMI-450 Manual de usuario
(160 paginas)
(160 paginas)
Redes RAD Data comm FOM-40 Especificaciones
(74 paginas)
(74 paginas)
Redes RAD Data comm LRS-24 Especificaciones
(76 paginas)
(76 paginas)
Redes RAD Data comm RICi-622GE Especificaciones
(184 paginas)
(184 paginas)
Redes RAD Data comm ASM-20 Especificaciones
(71 paginas)
(71 paginas)
Redes RAD Data comm E1 Especificaciones
(118 paginas)
(118 paginas)
Redes RAD Data comm ASMI-450 Especificaciones
(117 paginas)
(117 paginas)
Redes RAD Data comm FOM-T3 Especificaciones
(44 paginas)
(44 paginas)
Redes RAD Data comm FCD-G703 Manual de usuario
(2 paginas)
(2 paginas)
Redes RAD Data comm ASM-MN-214 Especificaciones
(32 paginas)
(32 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.047 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales