Rad-data-comm ASMI-450 Manual de usuario descargar pdf (Pagina 56)

Front-Panel Operating Instructions

3-16 ASMi-450 Installation and Operation Manual

SP PARAMETERS

See parameter definitions in Section 3-5.

SPEED_BPS Select AUTO whenever feasible. In this case, start the

communication with three Carriage Returns, to ensure

positive identification of terminal data rate.

Note

The automatic baud rate recognition procedure must be repeated after the

DTR line in the control port connector had been switched to OFF and then

ON again.

DATA Select the required number of data bits (same as on the

terminal).

PARITY Select the required parity (same as on the terminal).

INTERFACE • Select DCE when directly connected to the control

terminal.

• Select DTE when connected to a modem (future

option).

Note

The INTERFACE parameter only changes the direction of the interface

control (handshaking) signals, but not the functions of the interface pins.

Therefore, when connecting to a modem, it is necessary to use a cross cable.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 116 117

Sin comentarios

Rad-data-comm ASMI-450 Manual de usuario Pagina 56