RAD Data comm TDMoIP Gateway IPmux-16 Especificaciones Pagina 34
- Pagina / 99
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Chapter 3 Operation IPmux-16 Installation and Operation Manual
3-2 Operating Instructions
Table 3-1. IPmux-16 System Indicators and Switches
No Module Name Type Function
1 System RDY LED On: Device OK
OFF: Self-test in progress
Blinking: Malfunction detected
2 System PS1/PS2 LED On: Unit powered
Off: Unit not powered
3 System ALM LED Red: Alarm
Off: No alarm
4 Ethernet LINK LED Off: Link not active
On: Line OK
5 Ethernet ACT LED Off: No activity
On: Frame being transferred on line
6 Ethernet 100M LED Off: 10 MHz
On: 100 MHz
7 Ethernet FDX LED Off: Half duplex
On: Full duplex
8 E1 SYNC LED On: Port synchronized (no alarm)
Off: Unframed - Signal loss or AIS
detected
Framed - Signal loss, loss of frame or
AIS detected
Blinking: RDI detected (remote alarm)
9 Rear panel PS1/PS2 Switch Turns IPmux-16 power on and off
3.3 Operating Instructions
Turning IPmux-16 On – Without Control Terminal
IPmux-16 power switches are located on the back panel, as shown in Figure 3-2.
➤
To power up IPmux-16 without a terminal:
• Switch the PS1 power supply switch, located on the rear panel, to ON.
IPmux-16 can be optionally equipped with a second power supply (PS2). If
present, switch PS2 to ON.
After power-up, check the unit LED indicators, located on the right side of the
front panel, and the module indicators for proper operation (see Figure 3-1,
Figure 3-2, and Table 3-1).
- IPmux-16 1
- Warranty 2
- Regulatory Information 2
- Safety Warnings 3
- Telecommunication Safety 3
- Contents 5
- List of Figures 6
- Table of Contents 7
- List of Tables 8
- Chapter 1 9
- Introduction 9
- 1-2 Overview 10
- Features 11
- Mode of Operation 12
- Multibundling 12
- Internal Cross Connect 12
- 1.2 Physical Description 13
- 1.3 Functional Description 14
- Testing 15
- Timing Modes 15
- Operation Modes 15
- External Network Timing 16
- Single Source Clock Network 16
- Frame Format 17
- 1-10 Functional Description 18
- Packet Delay Variation 19
- PDVT (Jitter) Buffer 20
- Ethernet Throughput 21
- Round Trip Delay 22
- End-to-End Alarm Generation 23
- 1.4 Technical Specifications 24
- Ethernet 25
- Modules 25
- 1-18 Technical Specifications 26
- Chapter 2 27
- Installation 27
- 2.3 Package Contents 28
- 2.4 Equipment Needed 28
- Equipment Needed 2-3 29
- 2.5 Installation and Setup 30
- Location of Connectors 31
- Connecting the Control Port 31
- Connecting the Power 32
- Chapter 3 33
- Operation 33
- 3.3 Operating Instructions 34
- User Name and Password 35
- 3.4 Getting Started 36
- 3.5 Menu Operations 37
- 3-6 Menu Operations 38
- Main Menu 39
- Viewing System Information 39
- General Information 40
- Event Log 41
- 3.7 Configuring IPmux-16 42
- General Configuration 43
- Manager List 46
- Alarms Trap Mask 48
- ASCII Terminal Configuration 49
- Time/Date Update 50
- Software Download/Upload 50
- VIEW TRANSFER STATUS 53
- Status Transferring Data 53
- Error No Error 53
- ESC. Exit 53
- Set Default Parameters 54
- File System 54
- Configuring IPmux-16 3-23 55
- Physical Layer Configuration 56
- LAN Configuration 56
- E1/T1 Configuration 57
- Configuring IPmux-16 3-27 59
- 3-28 Configuring IPmux-16 60
- Configuring IPmux-16 3-29 61
- 3-30 Configuring IPmux-16 62
- Configuring IPmux-16 3-31 63
- Time Slots Configuration 64
- Configuring IPmux-16 3-33 65
- Configuring IPmux-16 3-35 67
- Setting VLAN and IP Support 68
- Compliance to standards: 71
- 3-40 Configuring IPmux-16 72
- Configuring IPmux-16 3-41 73
- 3-42 Configuring IPmux-16 74
- LAN Statistics 75
- LAN statistics 75
- Bundle Connection Status 76
- Configuring IPmux-16 3-45 77
- 3-46 Configuring IPmux-16 78
- Chapter 4 79
- Troubleshooting and 79
- Diagnostics 79
- Table 4-1. Event Types 80
- 4.2 Troubleshooting 81
- 4.3 Diagnostic Tests 82
- T1 FDL Support 83
- T1 PRM Support 83
- 4-6 Diagnostic Tests 84
- Appendix A 85
- Boot Sequence for 85
- Downloading Software 85
- A-2 Booting IPmux-16 86
- Accessing the File System 87
- A-4 Booting IPmux-16 88
- Appendix B 89
- SNMP Management 89
- MIB Structure 90
- SNMP Environment B-3 91
- SNMP Communities 92
- Authentication 92
- Network Management Stations 92
- Appendix C 93
- Telnet Operation 94
- System Security 94
- Warning 95
- Preliminary Procedure 96
- Checking the Download 97
- Connecting the DC Plug 99
Relacionado con productos y manuales para Gateways / Controladores RAD Data comm TDMoIP Gateway IPmux-16
(12 paginas)© 2020, manymanuals.es. Todos los derechos reservados | 0.026 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales