RAD Data comm MPW-1 Especificaciones descargar pdf (Pagina 5)

MPW-1 MP-4100 Ver. 2.0 1

Quick Start Guide

If you are familiar with the MPW-1 modules, use this guide to prepare it for

operation.

SFPs installed on MPW-1 modules may be equipped with a laser diode. In such

cases, a label with the laser class and other warnings as applicable will be

attached near the optical transmitter. The laser warning symbol may be also

attached.

For your safety:

• Before turning on the equipment, make sure that the fiber optic cable is intact

and is connected to the optical transmitter.

• Do not use broken or unterminated fiber-optic cables/connectors.

• Do not look straight at the laser beam, and do not look directly into the

optical connectors while the module is operating.

• Do not attempt to adjust the laser drive current.

• The use of optical instruments with this product will increase eye hazard.

Laser power up to 1 mW could be collected by an optical instrument.

• Use of controls or adjustment or performing procedures other than those

specified herein may result in hazardous radiation exposure.

ATTENTION: The laser beam may be invisible!

Preparations for Operation

1. If necessary, install the prescribed SFPs in the MPW-1 SFP sockets.

2. Insert the module in the assigned I/O slot.

3. Refer to the site installation plan, identify the cables intended for connection

to the MPW-1 connectors, and connect the cables as explained below.

Connecting Cables to Ethernet Ports

³ To connect cables to the optical Ethernet ports:

1. Connect each prescribed cable to the corresponding MPW-1 connector, ETH1,

ETH2 or ETH3. When two fibers are used, pay attention to connector polarity:

the transmitter output is at left-hand side.

Connecting Cables to Electrical Ethernet Ports

³ To connect cables to the MPW-1 electrical Ethernet ports:

1. Connect the prescribed cable to the corresponding connector, ETH1, ETH2, or

ETH3.

Warning

1 2 3 4 5 6 7 8 9 10 ... 107 108

Sin comentarios

RAD Data comm MPW-1 Especificaciones Pagina 5